Difference between revisions of "Molecule fragment"

From apm
Jump to: navigation, search
m
m
Line 11: Line 11:
  
 
Further molecules of prime interest are '''[[Mechanosynthetic carbon dioxide splitting|carbon dioxide CO<sub>2</sub>]] [[Mechanosynthetic water splitting|water H<sub>2</sub>O]] and nitrogen gas N<sub>2</sub>'''.
 
Further molecules of prime interest are '''[[Mechanosynthetic carbon dioxide splitting|carbon dioxide CO<sub>2</sub>]] [[Mechanosynthetic water splitting|water H<sub>2</sub>O]] and nitrogen gas N<sub>2</sub>'''.
The capability of handling those allows for tappingn the [[air as a resource]] for products that (almost) exclusively contain [[diamondoid molecular elements]] out of hydrogen carbon oxygen and nitrogen (HCON).
+
The capability of handling those allows for tapping the [[air as a resource]] for products that (almost) exclusively contain [[diamondoid molecular elements]] out of hydrogen carbon oxygen and nitrogen (HCON).
  
 
From the metals Aluminum and Titanium would be of interest.
 
From the metals Aluminum and Titanium would be of interest.
 +
 +
Resource molecules for other elements should preferentially be non or at least low toxic and easy to handle.
 +
* for fluorine and sulfur: SF<sub>6</sub> [http://en.wikipedia.org/wiki/Sulfur_hexafluoride sulfur hexafluoride] very heavy pretty inert gas, soluble in ethanol
 +
* for sulfur: CS<sub>2</sub> [http://en.wikipedia.org/wiki/Carbon_disulfide carbon disulfide] soluble in ethanol (toxic)
 +
* for chlorine: dissolved table salt NaCl
  
 
[[Category:Technology level III]]
 
[[Category:Technology level III]]
 
[[Category:Technology level II]]
 
[[Category:Technology level II]]
 
[[Category:Mechanosynthesis]]
 
[[Category:Mechanosynthesis]]

Revision as of 14:48, 29 December 2014

Moieties are the smallest building blocks handeded in the advanced mechanosynthesis of technology level III and II. When a simple resource molecule is picked up with an empty tooltip one always ends up with a few atoms on the tooltip. Some bonds need to be broken open to make it a reactive radical ready for deposition. It is generally not necessary to prepare the picked up molecule down until only one atom is left. That is in most cases one does not put down single atoms but small moieties (always bond molecules). Most often unused bonds are left hydrogen capped and and only one or two bonds are actively used - the one to the tooltip and the one to the workpiece. Hydrogen and oxygen with one and two bonds respectively are subject for single atomic deposition. The heavier elements of the same groups - the halogenes calcogenes - too.

simple respurce molecules

For mechanosynthesis of diamond ethyne C2H2 methane CH4 and traces of digermane Ge2H6 can be used. This has been toroughly analyzed.

Further molecules of prime interest are carbon dioxide CO2 water H2O and nitrogen gas N2. The capability of handling those allows for tapping the air as a resource for products that (almost) exclusively contain diamondoid molecular elements out of hydrogen carbon oxygen and nitrogen (HCON).

From the metals Aluminum and Titanium would be of interest.

Resource molecules for other elements should preferentially be non or at least low toxic and easy to handle.

  • for fluorine and sulfur: SF6 sulfur hexafluoride very heavy pretty inert gas, soluble in ethanol
  • for sulfur: CS2 carbon disulfide soluble in ethanol (toxic)
  • for chlorine: dissolved table salt NaCl