Difference between revisions of "Thermal energy transport"
From apm
(→The factors that go in: added link to moissanite) |
(→Related: added link to yet unwritten page * Thermal management in gem-gum factories) |
||
| Line 28: | Line 28: | ||
* [[Energy transmission]] | * [[Energy transmission]] | ||
* [[Diamondoid heat pump system]] | * [[Diamondoid heat pump system]] | ||
| + | * [[Thermal management in gem-gum factories]] | ||
[[Category:Thermal]] | [[Category:Thermal]] | ||
Revision as of 10:29, 25 May 2021
With Diamondoid heat transmission systems of technology level III enormous surface densities of heat flow (heating cooling) can be archived.
The factors that go in
- high surface to volume ratio (a thin sheet or dense stripes)
- very good thermal conductiocity of diamond (also for moissanite)
- good thermal capacity - the transport meium can be choosen for the operating temperature range
- high throughput of thermal mass due to fast capsule transport - the turning radius poses hard constraints on geometry though
- thermal conductivity of one dimensional sliding interfaces
[Todo: determine bottleneck in different situations - diagram]
Some possible applications
- in AP small scale factories of technology level III this is extended with diamondoid heat pump systems there the waste heat isn't too high and the situation far from extreme so turning radii do not play a role.
- high speed Aerial vehicles (See: medium movers)
- fusion power (figure eight loops for tokamaks?)
- geothermal stuff?
- active cooling for gemstone based metamaterials that maximize emulated toughness (speculative!)
- ...
