Same absolute speeds for smaller machinery
Or: "Same absolute speeds of smaller machinery"
Contents
Constancy as the natural scaling option for speed of operations of machinery
What are the motivating factors to keep speed of machinery motions constant across scales (as a first approximation)?
- Keeping relative scale deflections from machine motions constant across scales
- Keeping friction losses constant across scales
As it turns out both imply constant speeds across scales.
Keeping relative scale deflections from machine motions constant across scales
Keeping absolute speeds constant across scales
(or in other words keeping the same absolute speeds for smaller machinery)
can be considered as a natural choice when the main motivating factor is:
Same relative deflections across scales
Keeping friction losses constant across scales
While one might expect losses to go up due to
the well known scaling law of twice the surface area of half the volume applied to bearing area
There is also the compensating factor of
the poorly known scaling law of Higher throughput of smaller machinery.
Both of these scaling laws are linear.
Thus for machinery of scale invariant throughput density and scale invariant operation speeds
they exactly compensate.
(wiki-TODO: Maybe bring this into a more formalized math form to make the point more clear.)
Important caveats – Leading to scaling of speeds that differ from constancy
Alternate natural scaling options for speed of operations of machinery.
Since dynamic friction scales quadratically with speed (Hundredfold smaller frictionlosses of tenfold slower speeds) and
Productive nanomachiner takes up very little volume (Higher throughput of smaller machinery)
it is possible to cheat by trading decreased speeds for increased volume of nanomachinery.
See:
- Deliberate slowdown at the lower assembly levels
- Increasing bearing area to decrease friction
- Optimal sublayernumber for minimal friction
Optimal bearing technologies across scales likely change.
This makes deviating a bit from constant speeds across scales desirable.
See: Mesoscale friction
Dispelling eventual concerns regarding convergent assembly
Adding convergent assembly levels atop that are exponentially growing in size
only adds at best logarithmic amounts of additional friction.
Thus it for the most part can be ignored.
Discussion of an perhaps counterintuitive aspect of constant speeds across scales
When conceptually for visualization scaling up just space but not scaling time,
then the assumption of constant speeds across scales leads to magnified models featuring magnified speeds.
One might intuitively expect increased wear and such, but this is misled.
High encounter frequencies are just natural at small scales (Scale natural frequency).
One should remember that even today's macroscale roller bearing in the end feature nanoscale surface-on-surface contacts.
The only change when going to bearings that as a hole are at the nanoscale is
that they necessarily need to be atomically precise because
the wear of imprecisions of the scale of today's macroscale bearings would annihilate nanoscale bearings instantly.
Or rather imprecisions of the scale of today's macroscale bearing can be bigger than whole nanoscale bearings.
Related: Intuitive feel
