Increasing bearing area to decrease friction: Difference between revisions
→Related: added link to highly related page |
|||
| (7 intermediate revisions by the same user not shown) | |||
| Line 48: | Line 48: | ||
At some point assembly motions reach become similarly slow as the assembly motions. <br> | At some point assembly motions reach become similarly slow as the assembly motions. <br> | ||
At this point adding further [[sub- | At this point adding further [[sub-layer]]s there is no further reduction of frictive losses but rather frictive losses ride again. (eventually linearly). | ||
== Applications cases == | == Applications cases == | ||
| Line 57: | Line 57: | ||
== Related == | == Related == | ||
* '''[[Optimal sublayernumber for minimal friction]]''' | |||
* '''[[Deliberate slowdown at the lowest assembly level]]''' | * '''[[Deliberate slowdown at the lowest assembly level]]''' | ||
* [[Friction]], [[Superlubricity]] | * [[Friction]], [[Superlubricity]] | ||
* [[Infinitesimal bearings]] | * '''[[Infinitesimal bearings]]''' | ||
* [[Higher throughput of smaller machinery]] | * [[Higher throughput of smaller machinery]] | ||
* [[Mesoscale friction]] | |||
* [[Higher bearing surface area of smaller machinery]] | |||
[[Category:Surprising facts]] | |||
Latest revision as of 22:36, 29 March 2026
Friction in atomically precise diamondoid slide bearings ...
- is dominated by dynamic friction
which scales quadratically with speed:
1/2x speed => 1/4x friction | 1/10x speed => 1/100x friction - is proportional to the bearing area (2x area => 2x friction)
For details see: Friction
Side-note:
Low speed friction in macroscale bearings is quite different as it is
speed independent, area independent, load dependent.
The trick
This allows for a neat trick:
- Halving speed and
- doubling machinery
(this keeps the total throughput constant) leads to
- quartering friction losses due to reduced bearing speed
- doubling friction losses due to increased bearing area
Overall a halving of friction.
Q: But isn't doubling the amount of machinery a problem?
A: No! There is exceptionally little machinery needed to
get practical levels of throughput (aka product production rate).
This is due to the scaling law of higher throughput of smaller machinery.
Math
- P … (wearless) frictive losses – in W
- A … bearing area – in m²
- n … number of sub layers – an integer
- v … speed of assembly … in m/s
- gamma … dynamic friction coefficient – W/(m²*(m/s)²)
<math> P = \gamma A n v^2 </math>
Applying the trick:
<math> P' = \gamma A (x n) (v/x)^2 </math>
<math> P' = \gamma A n v^2 /x </math>
Related: Compenslow
This has limits though!
Limits to the trick
See math on main page: Limits to lower friction despite higher bearing area
- assembly motions can be slowed down by adding more sub layers.
- transport motions can not be slowed by adding more sub layers.
At some point assembly motions reach become similarly slow as the assembly motions.
At this point adding further sub-layers there is no further reduction of frictive losses but rather frictive losses ride again. (eventually linearly).
Applications cases
- This can be applied in the design of gem-gum on-chip factories to
optimize thickness of assembly layers of gem-gum factories
or just to get estimates for likely system geometries - This is the theoretical basis for infinitesimal bearings.